Anyone ever spray a PPG and HOK clear?

[tiller2nv]

I need to spray PPG to match the color of my truck then spray HOK for flames. Has anyone used HOK intercoat over PPG then do your tapeouts and then clear with HOK UC35?

 

[DDG]

I have with no problems. I actually use PPG primer then either
HOK, PPG or DuPont base then HOK for graphics topped off with DuPont clear. So you'll be fine.
Dirt

 

[BDsbigZRX]

yes, you will be fine, I do it all the time.

hey, I'm a poet and didn't know it! /ubbthreads/images/graemlins/haha.gif

 

[robert.tallon]

Same here. Never had a problem at all. Good luck!@ /ubbthreads/images/graemlins/beat.gif

 

[kylenlord]

I'm sorry to beat the proverbial dead horse, but I have a similar question. What about using ko-seal 2 as a wet on wet sealer with ppg basecoat on top? I could understand if it were used as a primer, and a physical adhesion was achieved, but would the chemical formulas link properly to allow for good bonding?
Thanks for any help,
Kyle

 

[tiller2nv]

[ QUOTE ]
I'm sorry to beat the proverbial dead horse, but I have a similar question. What about using ko-seal 2 as a wet on wet sealer with ppg basecoat on top? I could understand if it were used as a primer, and a physical adhesion was achieved, but would the chemical formulas link properly to allow for good bonding?
Thanks for any help,
Kyle

[/ QUOTE ]
So far so good with me. I used KO seal and PPG base and no problems yet.

 

[kylenlord]

Sounds good.
Thanks for the help,
Kyle