Hey everyone,
I just cleared over a candy flame job on my hood and I have a run and a lot of dirt particles in the clear. I don't want to sand and reclear because this is just going to happen again with the dust. The run is just because of poor lighting which I fix in my garage. I put 4 coats of selectclear 497-00 over the candy. Is there a way to sand and just buff it out to be shiny as the wet look? Plus since this is my first time doing flame like this, if I paint another panel without going over the black base with candy apple red like I did with the hood, will the candied black look different than the black with just clear?
I just cleared over a candy flame job on my hood and I have a run and a lot of dirt particles in the clear. I don't want to sand and reclear because this is just going to happen again with the dust. The run is just because of poor lighting which I fix in my garage. I put 4 coats of selectclear 497-00 over the candy. Is there a way to sand and just buff it out to be shiny as the wet look? Plus since this is my first time doing flame like this, if I paint another panel without going over the black base with candy apple red like I did with the hood, will the candied black look different than the black with just clear?