Flame job

[coz63]

This is a pic of a fresh flat black on candy, my first paint job.
But I had a couple of spots where the black bled through the tape is there anything I can do to get it off?

 

[TAZ]

The only thing I could think of is to resand all parts, then mask off the areas to cover the black areas, then reclear.
Meaning, if you have some blowthrough of black over the lime green, then tape it so you slightly go more into the green, then spot the black in so it makes the line nicer.
Hope this makes sense?!

 

[hoss]

how about a fat pinstripe

 

[coz63]

Yeah I was thinking about that I want to use one shot do I need to add anything to this paint ?

 

[Ultra Al]

If you are going to use 1Shot I would use the 6000 or 6001 1 Shot reducer, the 1 Shot hardner, then use a mist coat for your first clear coat after that your normal medium/wet coats. If your not going to clear over it just reduce to your favorite consistancy and go. You can use mineral spirits but the 1 shot reducer is better. AL

 

[coz63]

thanks I'm not clearing over cause the main paint is a flat

 

[Carcher7878]

dont they have a clear that isnt a gloss.. its only to protect the paint?

Archer

 

[coz63]

yeah but i used hot rod flatz which is a one stage paint and doesnt need the clear

 

[artworkbysteve]

artworkbysteve

if your kandy has been cleared with a catilized clear and then you shot your flat black color you should be able to simply take laquer thinner to remove bleed thru .....