Hi Guys
I'm a newbie needing a bit of advice! I've just painted my first project. a small sports car in 2k black with a devilbiss gti with a 1.4 tip. The Mippa paint product info suggested an inlet pressure between 2.5 and 5 bar, I shot it at 2.5 bar(37psi) and was pleased with the end product, I had some orange peel but was left nice and flat after colour sanding.I have recently seen a clip on you tube where the guy says a pressure of 27psi at the gun should be used.If I reduce my pressure to 27psi will this reduce the orange peel in my gun finish.
I have only used 2k and would like to try base and clear. Again what pressures are recommended also I keep getting conflicting advice on coverage. Two wet coats only, dust coat and 1 wet coat, two wet coats and a drop coat??? I'm at a loss and would really appreciate any advice.Many thanks
I'm a newbie needing a bit of advice! I've just painted my first project. a small sports car in 2k black with a devilbiss gti with a 1.4 tip. The Mippa paint product info suggested an inlet pressure between 2.5 and 5 bar, I shot it at 2.5 bar(37psi) and was pleased with the end product, I had some orange peel but was left nice and flat after colour sanding.I have recently seen a clip on you tube where the guy says a pressure of 27psi at the gun should be used.If I reduce my pressure to 27psi will this reduce the orange peel in my gun finish.
I have only used 2k and would like to try base and clear. Again what pressures are recommended also I keep getting conflicting advice on coverage. Two wet coats only, dust coat and 1 wet coat, two wet coats and a drop coat??? I'm at a loss and would really appreciate any advice.Many thanks