Marbleized Flames

[Braz]

I am shooting flames using the green Blue marbelizer. It says to clear with sg 100 or use adhereto before clear coating for adhesion. But i will need to let the base dry to lay out the flames. Do I need to use the Adhereto before shooting the marbelizer or can I just scuff it as usual? I want it to stay. Thanx! Braz

 

[myfamiliacc]

Depending on how elaberit the pattern is going to be, I usualy clear my base
let dry
then scuff
lay out the pattern
mask out the rest
spray on a wet coat of marbalizer
quickly cover with a wrinkled cheet of plastic (rurandwrap) and remove
let it flash, then remove your masking
and clear.

I'v never had any problems with adhiesion this way

 

[Bornhard]

safe way to do it is to spray your base. a few minutes later, coat in SG-100 and let dry 30 min to an hour (depending on temp). Lay out your flames and spray a thin coat or two of marbilizer with in the flames. Do the effect you want with the marbilizer and wait a few minutes. Remove the plastic wrap and then top coat with SG-100. You can top with adherto, but I like how SG-100 sort of smooths out marbilizer, so that's my choice. Keep the SG-100 fairly thin though and don't build it up too high. Wait a little while and then slowly peal up your tape.

good luck

 

[magicwheelder]

I am just about to do the same thing with a silver marbleize and a burgundy kandy if you have any pic you can post or any tips thanks