Next step for flames

H

hiett_431

Guest
I have my bike based and cleared, and now i'm ready to add my kandy brandywine ghost flames. I have read that I should wetsand with 800-1000 in the area that i want the flames. Spray the flames and re-clear. Do i need to reclear the entire part or just the area that has flames? I was also unsure of using a different clear as the original. HOK UC-35 was used over the base, but all I have left is a can that was opened about 9mos. ago, is it any good now? I also have NAPA Crossfire CC5000 high solid urethane clear. Is it a bad idea to use a different clear coat over the flames, then what was used over the base? The parts are mostly all plastic too, if this makes a difference.
Thanks for the help! /ubbthreads/images/graemlins/newbie.gif
 
M

MadHatter

Guest
You will want to clear the whole part. Spot clearing only causes more headaches.

As for using a different brnd of clear, you should be okay as long as it is the same type of paint. I have used different brands on the same project and had them work. It is always best to test this first on some scrap metal. I have heard horror stories in the past.

I also find that most of my supply's have a shelf life of around a year if they are stored properly.

Good luck.
 
M

maverickcustoms

Guest
I agree, spot clearing creates alot of problems. After any art, I always through on a couple of light coats of inner-clear over everything. Number one, it keeps dust out, two it can be scuffed, and three, it's like a "save" command on your computer.

/ubbthreads/images/graemlins/peace.gif Mav
 
T

TAZ

Guest
Yes, definately sand the complete part, flame, then reclear the complete pearl.
 
You must log in or register to reply here.
Top