PPG Chameleon Ghost flames over HOK Kameleon

[lantzsavage]

I am hoping to do some PPG ghost flames over my HOK Kameleon bike on the fairings and the tank in the same blue to red scheme. I was wondering if there are any compatibility problems that may occur?

Also any suggestions to do the ghost flames in something other than the PPG Kameleon would be greatly appreciated. I have never done these ghost flames before and I want to make sure I do it right the first time. I have pics posted below, these are the most recent.

 

[rex]

Wait for the more experienced with the HOK to jump in but since your job is cured out I don't see a prob.From what I'm gathering PPG still has a hand in HOK's line.

 

[TAZ]

Since the paint is hard, you shouldn't have any problems with applying any paint over the HOK surface.

If you use a blue pearl toner over the HOK base, and you do it very lightly, this should give it a neat effect *if you do it very lightly*. Just enough to give it a ghost effect. This way you will see through the pearl into the HOK.
The flames should be airbrushed on to give it this effect.
Do a test panel first just to make sure you like the effect.

 

[lantzsavage]

Actually I am considering sending it in to you to have it done because having never done it before, I just do not want to screw up the paint, it is just too expensive to risk it.

So I guess this turns from a compatibility question to a suggestion post.

Thanks Scott